 |
| Installation |
 |
| Installing Your Hammock Recliner |
| The Hammock Recliner can be hung from any overhead beam or tree limb - the height clearance required is 2.4 metres. If the beam or tree limb is higher than 2.4 metres, a rope or chain can be used and adjusted to suspend the Hammock Recliner. If the height available is less than the required 2.4 metres, the spreader bar rope can be shortened to adjust the hammock seat to a convenient distance off the ground. This is normally knee hight. |
| |
The spreader bar knot is a non - slip 'easy to undo' knot, which can always be retied.
To adjust - shorten the rope at one end only. Loosen the knot and pull the rope through until the correct length is obtained, then retie the knot. When retying the knot, it is important to always leave a 4cm rope tail for safety - cut off the surplus rope then burn and seal the rope end.
Finally, readjust the snap link, so the spreader bar is always suspended horizontally. |
|
 |
|
 |
| Spreader Bar knot |
|
Swivel Snap connection |
|
|
| |
| Maintenance |
|
| All components have been tested for load bearings strength. However, Hammock World recommends that customers periodically check all suspension points and hanging systems for wear and tear. Renew and replace all worn materials. Be Hammock Wise. |
| |
| Conveniently Portable |
|
Hang from any strong tree or sturdy overhead beam. The Hammock Recliner can be relocated according to your mood. A unique feature is the single point suspension, requiring minimal hanging space.
Just follow the sun in winter , the shade in summer or your mood anytime to your favourite "CHILL OUT " location. |
|
 |
|
| |
| |
| The Hammock Loop Attachment |
|
When connecting the hammock 'loops' on to the ends of the spreader bar, the rope knot must always be positioned on the outside of the loop. This will 'lock' the Hammock Recliner on to the spreader bar. To achieve this it may first be necessary to pull the rope knot to obtain some slack rope. The knot can now be passed through the hammock loop before sliding the loop onto the bar end - the rope can now be retentioned.
The spreader bar must always suspend horizontally when the Hammock Recliner is being used - the rope bend at the swivel snap can always be readjusted to level the spreader bar. |
| |
 |
|
 |
| |
Above: A handy repair knot
Left: To attach Hammock Recliner to spreader bar |
|
| |
